Skip to content
Ask how Mass Save incentives apply to your home (617) 539-7658
HVAC Financing Boston logo
Two heat pump outdoor units on a bright white wall

Sized for the whole house

Heat Pump Installation in Boston

Heating and cooling from one cold-climate system, sized to the house and installed with the program paperwork taken care of.

A Heat Pump Is Only as Good as Its Design

Here is the straight version. A modern cold-climate heat pump will heat a Boston house through January, cool it through August and do both on electricity, but only if somebody sized it properly and installed it carefully. Get the size wrong and you get rooms that never warm up, or a unit that short-cycles and wears itself out. So every job we do starts with a heat loss calculation built from your rooms, your windows, your insulation and the drafts you already know about. From there we decide whether the house wants a ducted air handler, ductless heads or a mix of both, and where the outdoor equipment can live without blocking a path or sitting under a dripping roof edge. The install itself is careful work: line sets run straight and covered, penetrations sealed, floors protected and controls set up for how you actually live. We also handle the program side, matching equipment to Mass Save rules and preparing the rebate and HEAT Loan paperwork so you do not have to figure it out alone. When we finish, you get a full walkthrough, and the workmanship is covered by our 10-year workmanship warranty.

What Goes Into an Install

The details vary house to house, but these are part of nearly every job.

  • Room-by-room load calculation

    Each room's heat loss worked out so the equipment matches the house.

  • Ducted, ductless or both

    The right delivery for the layout, whether that is an air handler, heads or a combination.

  • Program-qualifying equipment

    Cold-climate models that line up with Mass Save requirements.

  • Smart outdoor placement

    Units set where snow, roof runoff and walkways will not be a problem.

  • Clean line set work

    Refrigerant lines covered outside and hidden inside wherever the house allows.

  • Electrical needs flagged

    Circuit and service requirements identified early so nothing stalls on install day.

  • Commissioning

    Refrigerant charge, airflow and drainage checked, every zone tested both ways.

  • Paperwork and walkthrough

    Rebate and loan documents finished and the controls explained before we leave.

From Phone Call to Warm Rooms

  1. First conversation

    We go over the house, your fuel and your utility, then check what the rebate and HEAT Loan require for a home like yours.

  2. Measure and quote

    A visit gives us the heat loss numbers. Your written proposal puts equipment, cost, expected rebate and any financing on one sheet.

  3. Install and finish

    We install, test, walk you through everything and complete the program paperwork so you are not left chasing it.

Why Homeowners Choose Us for Installs

  • Sized, not guessed

    Every system comes from a heat loss calculation, never from the old unit's label.

  • Tidy from start to finish

    Protected floors, straight line sets and a clean house when we leave.

  • Covered in writing

    Our 10-year workmanship warranty stands behind the installation itself.

  • Load calculation every time
  • Cold-climate equipment
  • 10-year workmanship warranty
  • Paperwork handled

Ready to Talk About Your House?

Give us the basics and we will tell you what kind of system fits, what the programs could cover and what we would take off your hands.